Brady BP-IP300 用户指南

Control Panel

Press the menu key.

Select Setup > Interfaces.

: With faulty barcode contents or size 

specifications, printing is interrupted.
Off

: Printing is not interrupted if an error 

occurs. If barcode contents are faulty, the 
printer attempts to replace the incorrect data 
with valid characters (e.g. zeros). If barcode 
size specifications are faulty, a gray area is 
printed instead of the barcode.

On

Width of the printing area in the Monitor 
mode test function.
With the Automatic setting, the printout of the 
control sequences arriving at the printer 
occurs over the maximum printing width. You 
can reduce the printing area width down to 
2 inches (50.8 mm).

Automatic

Selects the primary card slot. Select one of the 
card slots on the back of the printer 
(CompactFlash, PC Card or Ext. 
CompactFlash)

Compact
Flash

Selects the character set table.
Switching the character set via software is not 
possible. You can access characters not 
available in the selected character set by using 
the Unicode table.

Windows 
1252

Sets the interface parameters Baud rate and 
Handshake for data transfer via the serial 
RS-232 interface.
Recommended settings are 115200 and 
hardware handshake.

115200
RTS/CTS

widthasc2dump