Motorola V60v 用户指南
16
Using the Battery and Charger
Installing and Removing the Battery
1.
Remove the battery from its protective clear plastic case.
2.
If the phone’s battery door is already in place, push
down on the battery door release latch and lift the
battery door off of the phone.
down on the battery door release latch and lift the
battery door off of the phone.
3.
Insert the battery, printed arrow down, into the battery
compartment.
compartment.
4.
Push down and insert the ridge at the bottom of the
battery door into the base of the phone, then push the
door down and snap it into place.
battery door into the base of the phone, then push the
door down and snap it into place.
䊳
To remove, make sure the power is off. Press the
battery release latch up and remove the battery from
the phone at a 45-degree angle.
battery release latch up and remove the battery from
the phone at a 45-degree angle.
Charging the Battery
To use the Traver Charger provided with your phone:
1.
Plug the travel charger into your phone with the
release tab facing up.
release tab facing up.
2.
Plug the other end of the travel charger into the
appropriate electrical outlet.
appropriate electrical outlet.
3.
When your phone indicates “Charge Complete,” press
the release tab and remove the travel charger.
the release tab and remove the travel charger.
It takes approximately 3.5 hours to fully recharge a completely
discharged battery. We recommend that you recharge the
battery before it becomes completely discharged.
discharged battery. We recommend that you recharge the
battery before it becomes completely discharged.
Important Note:
When you charge the battery, the battery power level
indicator in the upper right corner of the display shows
how much of the charging process is complete.
indicator in the upper right corner of the display shows
how much of the charging process is complete.