Enterasys csx5500 用户指南
USER’S GUIDE
148 CyberSWITCH
Currently, IP RIP is not supported across an UnNumbered WAN interface. For example, in the
following network setup, SITE1 could not advertise IP RIP information across the UnNumbered
WAN IP Interface to Router 2 (R2). Therefore, SITE1 would know about Networks 1 and 2, but
would not learn anything about Network 3. In this situation, a static route would have to be
configured on the CyberSWITCH. For information on the configuration of static routes, refer to
following network setup, SITE1 could not advertise IP RIP information across the UnNumbered
WAN IP Interface to Router 2 (R2). Therefore, SITE1 would know about Networks 1 and 2, but
would not learn anything about Network 3. In this situation, a static route would have to be
configured on the CyberSWITCH. For information on the configuration of static routes, refer to
.
IP RIP
OVER
D
EDICATED
C
ONNECTIONS
IP RIP is supported over LAN, Remote LAN, and numbered WAN interfaces. When devices are
connected over WAN links in which cost is not a major concern, such as dedicated links and semi-
permanent connections, RIP can be used to provide dynamic IP routing capability, as illustrated in
the following example:
connected over WAN links in which cost is not a major concern, such as dedicated links and semi-
permanent connections, RIP can be used to provide dynamic IP routing capability, as illustrated in
the following example:
i/f 1 1.0.0.1
i/f 2 2.0.0.1
i/f 1 2.0.0.2
i/f 2
R 1
ISDN
Network 1
(1.0.0.0)
Network 2
(2.0.0.0)
Network 3
(3.0.0.0)
"SITE1"
3.0.0.2
R 2
Static Route needed
for "SITE1" to R2
for "SITE1" to R2
CSX5500