Enterasys csx5500 用户指南
USER’S GUIDE
80 CyberSWITCH
N
ORTHERN
T
ELECOM
DMS100 C
USTOM
S
ERVICE
Note that you must set either EKTS or ACO to yes. You may not set both of them to yes.
B
ASIC
I
NFORMATION
FOR
O
RDERING
PRI ISDN L
INES
ISDN Primary Rate is a communications service that allows the system to make up to 23
connections over a single line. It uses a 4-wire T1 line that carries 24 channels, each providing 64000
bps bandwidth. The service uses channels 1 to 23 as bearer (B) channels to carry connections
between two systems. The 24th channel is used for signaling information (the data link).
connections over a single line. It uses a 4-wire T1 line that carries 24 channels, each providing 64000
bps bandwidth. The service uses channels 1 to 23 as bearer (B) channels to carry connections
between two systems. The 24th channel is used for signaling information (the data link).
The customer should request the following options for a Primary Rate Line that is connected
directly to a CyberSWITCH:
•
directly to a CyberSWITCH:
•
B8ZS encoding
•
ESF framing
•
all channels should be Circuit Switched Data
•
Hunt Group (if desired)
•
call bandwidth supported (56Kbps, 64Kbps, and/or 384Kbps)
•
CLID (calling line Id); usually there is no charge for this
In order to connect to the Primary Rate line, the customer must provide a Channel Service Unit
(CSU). If the line is provided by a LEC or IXC, the CSU is required by the phone company to protect
the phone network from any problems with customer premise equipment. At the time that the line
(CSU). If the line is provided by a LEC or IXC, the CSU is required by the phone company to protect
the phone network from any problems with customer premise equipment. At the time that the line
Northern Telecom DMS100 Custom Service
Provisioning Element
Setting
signaling
functional
PVC
1
TEI assignment
dynamic
maxkeys
3 is preferable
1-64 is acceptable
release key
no
ringing indicator
no
EKTS
no
ACO
yes
number of call
appearances
2
LCC
ISDNKSET
version
functional
CS
yes
PS
no