Lenovo d20 4158 硬件手册
Diagnostic Error Code
FRU/Action
001-032-XXX
System Device Controller failure
System Device Controller failure
System board
001-034-XXX
System Device Buffer Allocation failure
System Device Buffer Allocation failure
1.
Reboot the system
2.
Flash the system. See “Flash update
procedures” on page 251
procedures” on page 251
3.
Run memory test
4.
System board
001-035-XXX
System Device Reset condition detected
System Device Reset condition detected
System board
001-036-XXX
System Register error
System Register error
System board
001-038-XXX
System Extension failure
System Extension failure
1.
Adapter card
2.
System board
001-039-XXX
System DMI data structure error
System DMI data structure error
1.
Flash the system. See “Flash update
procedures” on page 251
procedures” on page 251
2.
System board
001-040-XXX
System IRQ failure
System IRQ failure
1.
Power-off/on system and re-test
2.
System board
001-041-XXX
System DMA failure
System DMA failure
1.
Power-off/on system and re-test
2.
System board
001-195-XXX
System Test aborted by user
System Test aborted by user
Information only
Re-start the test, if necessary
Re-start the test, if necessary
001-196-XXX
System test halt, error threshold exceeded
System test halt, error threshold exceeded
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
001-197-XXX
System test warning
System test warning
1.
Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
2.
Re-run test
3.
Replace the component that is called out
in warning statement
in warning statement
4.
Replace the component under test
001-198-XXX
System test aborted
System test aborted
1.
If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
it is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
2.
Flash the system and retest. See “Flash
update procedures” on page 251
update procedures” on page 251
3.
001-199-XXX
System test failed, cause unknown
System test failed, cause unknown
1.
2.
Flash the system and re-test
3.
Replace component under function test
001-250-XXX
System ECC error
System ECC error
System board
68
Hardware Maintenance Manual