UMAX 2200 用户指南

 
1.  Locate the USB cable that is provided.  Plug the rectangular connector end of this cable firmly into the 

USB port on the back of the computer. 

 

 

 
2.  Plug the square connector end of this cable into the port located on the back panel of the scanner. 
 

 
1.  Locate the USB cable that is provided.  Plug the rectangular end of the cable firmly into one of the 

USB ports.  IMac computer ports are located on the right side of the computer.  The USB port on other 
Macintosh computers is located on the back panel of the computer, or on a USB interface card. 

 
2.  Plug the square connector end of this cable into the port located on the back panel of the scanner. 
 

 
The instructions for connecting the SCSI cable are different for PC and Macintosh users.  Refer to the 
section below that applies to your computer type. 
 

 
1.  Power off the computer and the scanner. 
 
2.  Connect the SCSI cable to the interface card installed in your computer. 
 

  If you do not already have your SCSI interface card installed in your computer, install it 

now.  Refer to the installation instructions that came with your SCSI card for information about 
installing the board. 

3.  Attach the other end of the SCSI cable into the connection at the back of the scanner marked SCSI. 
 

 
1.  Power off the computer and the scanner. 
 
2.  Connect the SCSI cable to your Macintosh SCSI port.  
 
 
 
 

 

9