UMAX 3000 用户指南

17

If you are using an ASPI-compatible SCSI interface card with your computer and

scanner, refer to the installation instructions provided with the interface card.

After installing the card, do the following steps before connecting your scanner to

your computer.

! 

Confirm or reset the SCSI address of the scanner.

! 

Check the terminators in the SCSI Chain

! 

Make the SCSI cable connections.

Checking the SCSI Addresses
The illustration below shows the location of the SCSI address selector at the rear

panel of the scanner. The selector shows the SCSI address setting of the scanner. In

this case, it is #5 - the factory preset address.

After installing an ASPI-compatible SCSI interface card in your computer, proceed

with the following:

1.  Check the SCSI addresses of all devices on the SCSI chain. Is SCSI address #5

on the list of SCSI addresses in use?

 

5

 

2.  If not, then you can connect your computer to the scanner with a factory preset

SCSI ID of 5. You may jump to the section Check the Terminators in this

appendix.

SCSI ID