Yamaha RX-Z9 用户指南

■

If you want to increase the power output to the speakers, 
or want to use another power amplifier, connect an 
external amplifier to the pre out jacks.

• When RCA pin plugs are connect ed to the pre out jacks for 

output to an external amplifier, it is not necessary to use the 
corresponding SPEAKERS terminals. Set the volume of the 
amplifier connected to this unit to the maximum.

• The signal output through the FRONT OUT, CENTER OUT 

and SUBWOOFER jacks is affected by the TONE CONTROL 
settings.

• Signals will only be output from the FRONT OUT jacks if 

SPEAKERS B is set to “ZONE B” (see page 84) and 
SPEAKERS A is turned off (see page 84).

Front channel line output jacks.

Center channel line output jack.

Surround channel line output jacks.

Surround back channel line output jacks.

Presence channel line output jacks.

Connect one or two subwoofer(s) with built-in amplifier, 
such as the YAMAHA Active Servo Processing 
Subwoofer System, to these jacks.

• Adjust the volume level of the  subwoofer with the control on 

the subwoofer. It is also possible to adjust the volume level 
using this unit’s remote control (see page 76).

• Some signals may not be output from the SUBWOOFER jack 

depending on the Speaker Set (see page 74) and LFE Level (see 
page 70) settings.

■

If you want to input signals from another preamplifier, 
connect the external preamplifier to the FRONT IN/
CENTER IN jacks.

Line input to this unit’s front channel amplifiers. When 
connecting to these jacks, signals input to this unit’s 
preamplifier will not be output from the unit’s front 
amplifier.

Line input to this unit’s center channel amplifier. When 
connecting to this jack, signals input to this unit’s 
preamplifier will not be output from the unit’s center 
amplifier.

■

If you have a component with an i.LINK connector, you 
can enjoy digital audio from CD, DVD, Super Audio CD 
or DVD-A discs.

L

R

00EN.00_RXZ9_U.book  Page 27  Friday, October 17, 2003  11:40 AM