Yamaha RX-Z9 用户指南
GETTING STARTED
4
Notes on batteries
• Change all of the batteries if you notice the following conditions: the operation range of the remote control decreases, the indicator
does not flash or its light becomes dim.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and ma nganese batteries) together. Read the packaging carefully as these
• Do not use different types of batteries (such as alkaline and ma nganese batteries) together. Read the packaging carefully as these
different types of batteries may have the same shape and color.
• If the batteries have leaked, dispose of them immediately. Avoi d touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
■
Remote control
1
Open the battery compartment cover.
2
Insert three supplied batteries (AA, LR6)
according to the polarity markings (+ and –)
on the inside of the battery compartment.
according to the polarity markings (+ and –)
on the inside of the battery compartment.
3
After new batteries are correctly inserted,
press the RESET button in the battery
compartment using a ball point pen or
similar object.
press the RESET button in the battery
compartment using a ball point pen or
similar object.
(This does not clear the contents of the memory.)
4
Replace the cover by pressing until it snaps
into place.
into place.
■
GUI remote control
1
Press the
part and slide the battery
compartment cover off.
2
Insert two supplied batteries (AAA, R03)
according to the polarity markings (+ and –)
on the inside of the battery compartment.
according to the polarity markings (+ and –)
on the inside of the battery compartment.
3
Slide the cover back until it snaps into place.
Installing batteries in the remote controls
If the remote control is without batteries for more than
3 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. If the memory is cleared, insert new batteries,
set up the manufacturer code(s) and program any
acquired functions that may have been cleared.
3 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. If the memory is cleared, insert new batteries,
set up the manufacturer code(s) and program any
acquired functions that may have been cleared.
RESET button
1
3
2
00EN.00_RXZ9_U.book Page 4 Friday, October 17, 2003 11:40 AM