Zhone 2000 用户手册

- 156 -

The DHCP Server commands are all displayed on the DHCP Server 
Configuration menu (displayed by typing D on the Main menu).

Tasks in this chapter are all described beginning at this menu:

You may sign on as Supervisor or Network Manager to configure the IAD 
for use as a DHCP Server. Options that display in the DHCP Server 
Configuration menu are the same for both security levels. 

The commands in option B, Enable/Disable DHCP Debug Messages, are 
reserved for use by Paradyne network engineers.

When you enable DHCP Server, the IAD sequentially displays and 
processes the required configuration commands beginning with Enable 
DHCP Server.

To enable or disable DHCP Server, follow these steps:

1. Type E to select Enable/Disable DHCP.
2. If DHCP Relay is enabled, the IAD displays this prompt:

DHCP Server and DHCP Relay cannot both be enabled!

Do you wish to disable DHCP Relay? (N)

Type Y to disable DHCP Relay and enable DHCP Server, and proceed 
to step 4.

*******************************************

DHCP Server Configuration Menu

*******************************************

E. Enable/Disable DHCP
H. Enable/Disable Checking Additional DHCP Servers
B. Enable/Disable DHCP Debug Messages
I. Configure DHCP Server Parameters
P. Configure DHCP Address Range Pool
C. Configure DHCP Client Entry
F. Display DHCP Configuration
S. Display DHCP Server Statistics
A. Display DHCP Server Assigned Addresses
U. Display DHCP Server Unassigned Addresses
D. Display DHCP Entry Details
X. Delete A DHCP Client Entry
Y. Delete A DHCP Assignment Entry

 

Be sure to reset the IAD (page

) when after configuring the 

IAD as a DHCP Server. Resetting the IAD causes the 
configuration changes to take effect.