Zhone 2000 用户手册

下载
页码 297
2000-A2-GB20-10
- 10 -
February 2004
vertically, ensure at least 3 inches of distance between other IADs or other 
equipment. 
Wiring Requirements
Make sure that the telephone wiring, LAN and WAN cables reach the IAD 
and can be dressed in a manner that is safe for the wiring, does not pull or 
create lateral stress on the connectors or ports on the rear of the IAD, and 
does not present a trip hazard to personnel working in the vicinity of the 
equipment. Do not connect any cables or wiring at this time.
Connect 
via 
Terminal 
Emulator
The IAD is configured and managed from either the console or Ethernet 
port. Most network engineers use Telnet to access the IAD via Ethernet. 
After you use a terminal emulator program via the console port to set the 
IP address, you may continue to use a terminal emulator via the console 
port if you choose.
Before you can connect to the IAD via Telnet, make sure the IP address is 
set correctly for this network. To do so, follow the steps, each described in 
detail below:
1. Connect the IAD to a PC 
2. Log in to the IAD
3. Set the IP address 
Connect the IAD to a PC
To connect the IAD to a PC via the console port:
1. Turn off both devices and insert the male connector of a DB9 serial 
cable into the console port on the IAD.
2. Insert the female connector of the cable into a serial (COM) port on 
your PC.
Power Up the IAD
1. With the console cable connected, on 2/4/8-port IADs plug the AC 
power adapter into the IAD. On 16/24-port IADs, turn on the power 
 
NOTE
2/4/8-port IADs may be stacked on top of one another, when 
mounted horizontally. 16/24-port IADs may be rack mounted.
 
NOTE
After a period of inactivity (three minutes by default), the IAD 
automatically terminates console-based and Telnet sessions 
to maintain security. To change this value, see 
 
NOTE
Be sure that the IAD and PC are both powered OFF before 
connecting the console cable. If both devices are not turned 
off when you connect the cables, you may place the IAD in an 
unstable state, and you may need to reset one or both 
devices before you can perform configuration tasks.
 
NOTE
 for console port specifications.