Zhone 2000 用户手册

- 59 -

The tasks described in this section all begin on the G2237 xDSL 
Configuration menu. The tasks are described so you can proceed through 
them sequentially. You should review and update each of these options as 
necessary, and reset the IAD when you finish WAN configuration.

To configure the SDSL interface, Type 2 (Configure Physical Interface) on 
the WAN Configuration menu to display the G2237 xDSL Configuration 
menu: 

1. Type 2 to display the Configure CPE/CO Mode menu.

Type 1 to select CPE, or type 2 to select CO mode.

2. The IAD sets the mode and displays the menu.
3. Press Escape to return to the SDSL Configuration Menu.

LAN LINK

LAN ACT

WAN LINK

VOICE

POWER

This section is only for configuring the SDSL WAN interface 
on the JF2104, JF2104i and JF2108.

******************************************

G2237 xDSL Configuration

******************************************

Current Interface Type is: SDSL.
Mode: CPE, Rate Mode: NOKIA AUTO-CYCLE,
Line Rate: 88K, Debug: DISABLED

1. Select xDSL Interface Type
2. Select CPE/CO Mode
3. Enable/Disable Adaptive Rate Mode
4. Select Line Rate
D. Enable/Disable G2237 xDSL Debug Messages

*******************************************

Configure CPE/CO Mode

*******************************************

Current Mode: CPE
 1. CPE
 2. CO