Zhone 2000 用户手册

- 78 -

7. The IAD saves the configuration and displays the PVC Configuration 

menu where you may continue with other PVC management tasks.

8. Reset the IAD (page

) when you finish PVC configuration.

To modify a PVC, follow these steps:

1. On the ATM PVC Configuration menu, type 2 to select Modify Existing 

PVC.

2. The IAD displays the following port table, and a prompt:

1

0

40

RFC 1483 (with LLC Encapsulation) 3641

UBR

2

100 39

RFC 1483 (with LLC Encapsulation

4

CBR

--------

Total = 3645 cps

Maximum PCR this interface can support = 4830 cps

Select Port: [1-8]

Type the port number and press Enter.

3. The IAD displays a prompt for the VPI:

Enter Virtual Port Identifier (VPI):

Type a VPI value between 0 and 255 (default 0) and press Enter.

4. The IAD displays a prompt for the VCI:

Enter Virtual Circuit Identifier (VPI):

Type a VCI value between 32 and 65535 (the default is 38 for data and 
39 for voice) and press Enter.

5. The IAD displays the ATM Encapsulation Configuration menu.

Select the encapsulation you want to assign to this PVC. Proceed to the 
corresponding section and perform the steps to set up the encapsulation 
you’ve chosen.

1. Type 1 to select AAL5, or type 2 to select AAL0 encapsulation. 
2. The IAD displays the ATM Service Category Configuration menu:

*****************************************

ATM Encapsulation Configuration

*****************************************

Current Encapsulation: NONE

1. AAL5 (None)
2. AAL0 (None)
3. Proprietary Voice
4. RFC 1483 (using VC Muxing)
5. RFC 1483 (with LLC Encapsulation)
6. RFC 2364 (PPPoATM with LLC Encapsulation)
7. RFC 2364 (PPPoATM using VC Muxing)
8. AAL1/CES
9. AAL2 (LES, NBT)