Zhone 5100 安装指南

CHAPTER 2
Installation

    

To wall-mount the 5100/6100 VDR, you need the following:
•

The hardware supplied in the sealed bag that accompanied the 5100/6100 VDR

•

A site with enough clearance to access the cables both before and after it is installed

First, you can use the template procedure to locate the bracket placement on the wall, and then 

the next procedure details the actual placement of the 5100/6100 VDR unit on the selected wall 

space. 

1. Open the file named Wall Mount Template_LeftSide.PDF, which is located on the supplied 

CD-ROM. 

2. Print the file, and make sure the “Fit to Page” box is not enabled. 

Note. The templates must be printed full scale for accurate reproduction.

3. Repeat steps 1 and 2 for the file named Wall Mount Template_RightSide.PDF. 
4. Place the mounting holes 18" apart as shown on the template so you have a complete profile 

of the VDR with brackets attached. Do not tape the templates together.

5. Mark the spots where the supporting screws will go and discard the template.

Now you are ready to install the 5100/6100 VDR unit to the prepared wall.

1. Verify that sufficient clearance exists for visual inspection as well as for manipulating the 

cables on the rear panel.

2. Use the eight wall-mounting screws to attach the mounting brackets to the 5100/6100 VDR. 

See Figure 2-2 on 15.

 Caution. Use of longer screws could result in damage of internal components.

!