Zhone 5100 安装指南
Setting up an initial configuration
Vpacket 5100/6100 Series Installer’s Guide
41
Configuring voice services
To configure voice services for up to 24 lines (depending on 5100/6100 VDR model), you must
have already established data services. You can choose to run the voice traffic over the LAN or
through the WAN interface. If you want to run the voice traffic over the LAN, you set the voice
gateway to the LAN IP address; if you want to run the voice through the WAN interface, you set
the voice gateway to match the WAN IP address.
In this example, the procedure explains the steps to running the voice traffic through the WAN
have already established data services. You can choose to run the voice traffic over the LAN or
through the WAN interface. If you want to run the voice traffic over the LAN, you set the voice
gateway to the LAN IP address; if you want to run the voice through the WAN interface, you set
the voice gateway to match the WAN IP address.
In this example, the procedure explains the steps to running the voice traffic through the WAN
interface.
Figure 4-4. Voice services through the WAN interface
To configure voice services
1. Access the CLI main configuration level.
2. At the VPacket# prompt, issue the show ip command to view the current IP interface values.
Example:
2. At the VPacket# prompt, issue the show ip command to view the current IP interface values.
Example:
VPacket# show ip
ACTIVE indicates this is the current operational setting
CONFIG indicates this has been configured but not activated
-------------------------IP INTERFACE----------------------
INTERFACE NAME IP ADDRESS NET MASK
ACTIVE lan 10.10.10.254 255.255.255.0 Not NATed
ACTIVE wan 205.176.94.11 255.255.255.0
CONFIG Default Gateway 1.1.1.254
ACTIVE Voice Ip Address 1.1.1.1
-----------------------------------------------------------
VPacket#
Phone
WAN
LAN interface
6100 VDR
Internet
Public routed
IP address: 205.176.94.11
IP address: 205.176.94.11
Voice
PBX
Private LAN address: 10.10.10.254
Voice interface