Zhone 5100 安装指南

This chapter describes basic troubleshooting procedures for scenarios involving installation and 
configuration of the 5100/6100 VDR and normal operation under specific conditions.

For installation and initial configuration you need to establish a direct serial connection from the 

5100/6100 VDR to a terminal or PC. You also need to open a session in HyperTerminal or 

another emulation program.

To use the CLI for the first time, set your console and communications software to use the 
following parameters:

•

Baud rate: 57,600 bps

•

Data  bits:  8

•

Parity:  None

•

Stop bits: 1

•

Flow control: None

Once connectivity to the 5100/6100 VDR is established, a prompt asks you to specify a user 

name and password. By default, the user name is user and the password is user (both all 

lowercase). After you enter the user name and password, you enter configuration mode and can 

use the CLI to configure the 5100/6100 VDR.

Note. Vpacket Communications, Inc. recommends that you change the password by 

issuing the set user modify command.

After the 5100/6100 VDR has been initialized you can choose to manage the 5100/6100 VDR 

from a remote telnet session. You can follow these steps to establish a telnet session.
1. Click Start and select Run. 
2. Enter telnet <IP address of your VDR>.
3. When the login prompt appears, enter admin.
4. When the password prompt appears, enter admin.

The VPacket # prompt should now appear.