Zhone 6210 用户指南

3. Using the Web Interface

 

3. Click in the check box to enable the IGMP proxy. Select the WAN connection 

that IGMP messages should be sent to.

4. The Apply button will temporarily save these settings. To make the change 

permanent, click on Tools and select System Commands. On the System 
Commands page, click on Save All.

 

If the modem is connected to more than one network, you may need to set up a 
static route between the networks. A static route is a predefined pathway that 
network information must travel to reach a specific host or network. You can use 
static routing to allow different IP domain users to access the Internet through the 
modem. 

To enable Static Routing:

1. From the Home screen, click on Advanced.

2. Under Advanced, select Static Routing.  

3. Specify the New Destination IP. This is the address of the remote LAN network 

or host to which you want to assign a static route. Enter the IP address of the 
host for which you wish to create a static route here. For a standard Class C IP 
domain, the network address is the first three fields of the New Destination IP, 
while the last field should be 0. The Subnet Mask identifies which portion of an 
IP address is the network portion, and which portion is the host portion. For a 
full Class C Subnet, the Subnet Mask is 255.255.255.0. 

4. Specify the Gateway address. This is the IP address of the device that allows 

contact between the modem and the remote network or host.