Zhone 6301 安装指导
4
Optional Cable
The Hotwire 6341/6342 SDSL Routers are typically configured remotely by the service
provider. The following optional cabling and adapter are only used with this product to
configure the router locally:
provider. The following optional cabling and adapter are only used with this product to
configure the router locally:
-
Console cabling: Straight-through cable with 8-pin non-keyed modular plugs
(Part No. 035-0276-1431)
(Part No. 035-0276-1431)
-
Console adapter:
— 8-pin modular to DB9 adapter plug (Part No. 002-0093-0031), or
— A configurable RJ to DB9 adapter wired as shown in Cables & Connectors
on page 14.
Installing the DSL Access Wiring
The local loop terminates at the punchdown block or NID. Wiring must be connected
from the customer premises side of the punchdown block or the NID to an RJ11 jack.
Typically, the punchdown block is installed in commercial locations and the NID is
installed in residential locations.
from the customer premises side of the punchdown block or the NID to an RJ11 jack.
Typically, the punchdown block is installed in commercial locations and the NID is
installed in residential locations.
"
Procedure
1. Access the punchdown block or NID.
!
WARNING:
Do not continue unless the DSL access line from the local loop has been
disconnected at the NID or punchdown block. Refer to Important Safety
Instructions on page 19.
disconnected at the NID or punchdown block. Refer to Important Safety
Instructions on page 19.