Zhone 6301 安装指导
13
Hotwire 6371 RADSL Router Configuration Setup
The Console connection is optional. Refer to
Installing the Hotwire 6371 RADSL Router
on page 9 for details.
The Console cable is connected to a VT100-compatible terminal or a PC running a
terminal emulation program. Verify the terminal settings:
terminal emulation program. Verify the terminal settings:
H
Data rate set to 19.2 kbps (19200 bps)
H
Character length set to 8
H
Parity set to None
H
Stop bits set to 1
H
Flow control set to Off or None
Local Console Access
When the local console connection is first established, access control to the DSL router
displays an initial prompt of
displays an initial prompt of
Login>
.
"
Procedure
1. At the initial prompt of
Login>
, enter the factory default Login ID of
paradyne
.
2. At the
password>
prompt, enter the factory default Password of
abc123
.
3. At the next prompt for System ID, the factory default is
CUSTOMER>
.
Enter
show system
to display hardware/firmware information and Selftest Results
(optional).
Refer to the
Hotwire DSL Routers User’s Guide for configuration settings and
command line entries.
Increasing the Number of End-User Systems
A single PC is attached to the Hotwire 6371 RADSL Router by using an Ethernet
crossover cable.
crossover cable.
The Hotwire 6371 RADSL Router can support differing numbers of end-user systems
depending on the functions that are enabled and traffic loading. Typical configurations
will provide support for up to 32, 64, or 256 hosts (end-user systems).
depending on the functions that are enabled and traffic loading. Typical configurations
will provide support for up to 32, 64, or 256 hosts (end-user systems).
To increase the number of PCs, connect all PCs to an Ethernet hub using a
straight-through cable. The number of end-user systems can be increased with the use
of subnets utilizing static addressing or by using a default gateway connection.
straight-through cable. The number of end-user systems can be increased with the use
of subnets utilizing static addressing or by using a default gateway connection.