Zhone 2004 用户指南

C o n f i g u r a t i o n

This section describes the tasks required to configure the Dynamic Host 
Configuration Protocol (DHCP) server on the LAN connection.

DHCP allows for dynamic allocation of network addresses and configurations 
to newly attached hosts. DHCP reduces the amount of work required to 
administer a large network.

When DHCP is enabled, it dynamically assigns an IP address to each device 
assigned to the DHCP server on the IAD. You must identify the Ethernet 
Interface to correctly implement DHCP Server on your IAD.

You must complete at least these tasks to configure the DHCP server:

•

Enable DHCP (default is disabled) (page 4-60)

•

•

Configure the DHCP address range pool (page 4-61)

The DHCP Server commands are all displayed on the DHCP Server 
Configuration menu, which is displayed by typing “D” on the Main menu 
(Figure 2.2). Remember always to reset the IAD when you have finished 
making DHCP Server configuration changes.

You may sign on as Supervisor or Network Manager to configure the IAD for 
use as a DHCP Server. Options that display in the DHCP Server 
Configuration menu are the same for both security levels.