Zhone 2208 用户指南
2-12
2 0 0 0 - A 2 - G B 2 1 - 0 0
NOTICE:
You may temporarily connect the IAD directly to a PC for Telnet
configuration (without going through a hub or router). The Ethernet
receiver automatically detects the type of Ethernet cable
(customer-supplied).
configuration (without going through a hub or router). The Ethernet
receiver automatically detects the type of Ethernet cable
(customer-supplied).
WAN Connections
WAN connections vary, based on the WAN interface on your IAD.
•
The JetFusion 2308 is an SDSL-equipped IAD and uses an RJ11 connector to
connect to the rear panel WAN connection. To make the connection, plug the
SDSL cable into the RJ11 WAN connector. (Refer to SDSL Connector Pin
•
The JetFusion 2208 is a T1/E1-equipped IAD and uses an RJ48 connector on
the IAD rear panel for WAN connection. To make the connection, plug the
cable from the ATM network into the RJ45 WAN connector. (Refer to T1/E1
Telephone Connections
The 2208/2308 IADs provide eight RJ11 ports for POTS devices. These
devices may be POTS telephones, modems, FAX machines, or other
POTS-compatible devices.
devices may be POTS telephones, modems, FAX machines, or other
POTS-compatible devices.
Confirming Proper Setup
When you have completed the tasks in this chapter, reset the IAD and test
your configuration for proper data and voice operation. Reset the IAD
(page 2-8) to synchronize the physical connections using the verification
procedure described in Chapter 8, Verification.
your configuration for proper data and voice operation. Reset the IAD
(page 2-8) to synchronize the physical connections using the verification
procedure described in Chapter 8, Verification.