ZyXEL p-660h-61 用户指南
Prestige 660H Series User’s Guide
Firmware and Configuration File Maintenance
34-5
Table 34-3 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Remote File
This is the filename on the Prestige. The filename for the firmware is “ras” and for the
configuration file, is “rom-0”.
configuration file, is “rom-0”.
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Refer to section 34.2.5 to read about configurations that disallow TFTP and FTP over WAN.
34.3 Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this function erases
the current configuration before restoring a previous back up configuration; please do not attempt to
restore unless you have a backup configuration file stored on disk.
the current configuration before restoring a previous back up configuration; please do not attempt to
restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your Prestige since
FTP is faster. Please note that you must wait for the system to automatically restart after the file
transfer is complete.
FTP is faster. Please note that you must wait for the system to automatically restart after the file
transfer is complete.
WARNING!
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR Prestige.
PERMANENTLY DAMAGE YOUR Prestige.
34.3.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file upload in
this chapter.
this chapter.
Figure 34-3 Telnet into Menu 24.6
1.
Launch the FTP client on your computer.
Menu 24.6 -- System Maintenance - Restore Configuration
To transfer the firmware and configuration file to your workstation, follow the
procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-0 is the
remote file name on the Prestige. This restores the configuration to
your Prestige.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Prestige manual.
Press ENTER to Exit:
procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-0 is the
remote file name on the Prestige. This restores the configuration to
your Prestige.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Prestige manual.
Press ENTER to Exit: