ZyXEL nbg-4615 用户指南

 Chapter 8 Easy Mode

NBG4615 User’s Guide

Use this screen to configure security for your the Wireless LAN. You can enter the 
SSID and select the wireless security mode in the following screen.

Note: You can enable the Wireless function of your NBG4615 by first turning on the 

switch in the back panel.

Figure 42   Wireless Security

The following table describes the general wireless LAN labels in this screen.

Table 23   Wireless Security

Wireless 
Network 
Name (SSID)

(Service Set IDentity) The SSID identifies the Service Set with which a 
wireless station is associated. Wireless stations associating to the access 
point (AP) must have the same SSID. Enter a descriptive name (up to 32 
keyboard characters) for the wireless LAN. 

Security 
mode

Select WPA-PSK or WPA2-PSK to add security on this wireless network. 
The wireless clients which want to associate to this network must have 
same wireless security settings as this device. After you select to use a 
security, additional options appears in this screen. 

Select No Security to allow any client to connect to this network without 
authentication.

Wireless 
password

This field appears when you choose wither WPA-PSK or WPA2-PSK as 
the security mode.

Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.

Verify 
password

Type the password again to confirm.

Apply

Click Apply to save your changes back to the NBG4615.

Cancel

Click Cancel to close this screen.

WPS

Click this to configure the WPS screen.

You can transfer the wireless settings configured here (Wireless 
Security screen) to another wireless device that supports WPS.