ZyXEL p-2302hw-p1 用户手册
P-2302HW/HWL-P1 Series User’s Guide
Chapter 5 Wireless LAN
101
Figure 48 OTIST: In Progress on the Wireless Device
These screens close when the transfer is complete.
5.5.1 Notes on OTIST
1 If you enable OTIST in a wireless device, you see this screen each time you start the
utility. Click Yes to search for an OTIST-enabled AP (in other words, the ZyXEL
Device).
Device).
Figure 49 Start OTIST?
2 If an OTIST-enabled wireless device loses its wireless connection for more than ten
seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually
have the wireless device search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)
have the wireless device search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)
3 After the wireless device finds an OTIST-enabled AP, you must click Start in the ZyXEL
Device’s Network > Wireless LAN > OTIST screen or hold in the Reset button on the
ZyXEL Device for one or two seconds to transfer the settings again.
ZyXEL Device for one or two seconds to transfer the settings again.
4 If you change the SSID or the keys on the ZyXEL Devices after using OTIST, you need
to run OTIST again or enter them manually in the wireless device(s).
5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run
OTIST. Therefore, if a new wireless device joins your wireless network, you need to run
OTIST on the AP and ALL wireless devices again.
OTIST on the AP and ALL wireless devices again.
5.6 MAC Filter
Use this screen to change your ZyXEL Device’s MAC filter settings, click Network >
Wireless LAN > MAC Filter. The screen appears as shown.
Wireless LAN > MAC Filter. The screen appears as shown.