Sharp MX-M1100 操作指南

Is the machine specified correctly in the 
software application that you are using 
for printing?

Make sure that the printer driver of the machine is 
selected in the Print window of the application.
If the printer driver does not appear in the list of 
available printer drivers, it may not be installed correctly. 
Remove the printer driver and then install it once again.

☞

Software Setup Guide

Are the network connection devices 
operating normally?

Make sure that the routers and other network 
connection devices are operating correctly. If a device is 
not powered on or is in an error state, see the manual of 
the device to correct the problem.

Is the I/O timeout setting too short?

If the I/O timeout setting is too short, errors may occur 
while writing to the printer. Ask the administrator of the 
machine to configure an appropriate time in "I/O Timeout".

➞ System Settings (Administrator) > "Printer Settings" > 

"Interface Settings" > "I/O Timeout"

Was a Notice Page printed?

A Notice Page will be printed to indicate the cause of the 
problem if a print job cannot be performed as specified 
and the cause is not shown in the display. Read the 
printed page and take appropriate action.
For example, a notice page will be printed in the 
following situations.

• The print job is too large to fit in memory.

• A function that has been prohibited by the 

administrator is specified.

* By factory default, Notice Pages are not printed.

Have functions been disabled by the 
administrator?

When user authentication is enabled, the functions that 
you can use may be restricted in your user settings. 
Check with your administrator.

Does the paper type setting of the 
selected tray specify a type of paper that 
cannot be used for two-sided printing?

Check "Tray Settings" in the system settings.
 If the [Disable Duplex] checkbox is selected 

, 

two-sided printing using that tray will not be possible. 
Change the paper type setting to a type that can be 
used for two-sided printing.

➞ System Settings > "Paper Tray Settings" > "Tray 

Settings" > "Change"

Are you using a special size or type of 
paper?

For the paper types and sizes that can be used for 
two-sided printing, see "SPECIFICATIONS" in the 
Safety Guide.

Have functions been disabled by the 
administrator?

Some functions may have been disabled in the system 
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that 
you can use may be restricted in your user settings. 
Check with your administrator.

Have the peripheral devices that are 
installed on the machine been 
configured in the printer driver?

Open the printer properties and click the [Auto 
Configuration] button on the [Configuration] tab. 
(Windows)
* If auto configuration cannot be executed, see the 

Software Setup Guide.