Amana ASD2524VE 用户手册

■

Are the gaskets dirty or sticky? Clean gaskets with mild 
soap and warm water.

■

Is a light bulb loose in the socket or burned out? See  
“Changing the Light Bulbs.”

■

Is the dispenser light set to OFF? The dispenser light will 
operate only when the levers are pressed. If you want the 
dispenser light to stay on continuously, set the dispenser light 
to ON, or NIGHT LIGHT or AUTO or HALF or DIM. See “Water 
and Ice Dispensers.”

■

Is the dispenser light set to NIGHT LIGHT or AUTO? If the 
dispenser is set to the NIGHT LIGHT or AUTO mode, be sure 
the dispenser light sensor is not blocked. See “Water and Ice 
Dispensers.”

■

New installation? Allow 24 hours following installation for 
the refrigerator to cool completely.

■

Door(s) opened often or left open? Allows warm air to enter 
refrigerator. Minimize door openings and keep doors fully 
closed. 

■

Large load of food added? Allow several hours for 
refrigerator to return to normal temperature. 

■

Controls set correctly for the surrounding conditions? 
Adjust the controls a setting colder. Check temperature in 
24 hours. See “Using the Controls.”

NOTE: Some moisture buildup is normal.

■

Humid room? Contributes to moisture buildup.

■

Door(s) opened often or left open? Allows humid air to 
enter refrigerator. Minimize door openings and keep doors 
fully closed.

■

Refrigerator connected to a water supply and the supply 
shutoff valve turned on? Connect refrigerator to water 
supply and turn water shutoff valve fully open. 

■

Kink in the water source line? A kink in the line can reduce 
water flow. Straighten the water source line. 

■

Ice maker turned on? Make sure wire shutoff arm or switch 
(depending on model) is in the ON position. 

■

New installation? Wait 24 hours after ice maker installation 
for ice production to begin. Wait 72 hours for full ice 
production. 

■

Large amount of ice recently removed? Allow 24 hours for 
ice maker to produce more ice. 

■

Ice cube jammed in the ice maker ejector arm?
Remove ice from the ejector arm with a plastic utensil. 

■

Reverse osmosis water filtration system connected to 
your cold water supply? This can decrease water pressure. 
See “Water Supply Requirements” in either the Installation 
Instruction booklet or the Use & Care Guide.  

NOTE: This is an indication of low water pressure.

■

Water shutoff valve not fully open? Turn the water shutoff 
valve fully open.

■

Kink in the water source line? A kink in the line can reduce 
water flow. Straighten the water source line. 

■

Reverse osmosis water filtration system connected to 
your cold water supply? This can decrease water pressure. 
See “Water Supply Requirements.”

■

Questions remain regarding water pressure? Call a 
licensed, qualified plumber.

■

New plumbing connections? New plumbing connections 
can cause discolored or off-flavored ice. 

■

Ice stored too long? Discard ice. Wash ice bin. Allow 
24 hours for ice maker to make new ice. 

■

Odor transfer from food? Use airtight, moisture proof 
packaging to store food. 

■

Are there minerals (such as sulfur) in the water? A water 
filter may need to be installed to remove the minerals. 

■

Is there a water filter installed on the refrigerator? Gray or 
dark discoloration in ice indicates that the water filtration 
system needs additional flushing. 

■

Freezer door closed completely? Close the door firmly. If it 
does not close completely, see “The doors will not close 
completely.”

■

Ice bin installed correctly? Be sure the ice bin is firmly in 
position.