Jet dc-1100c 补充手册
above and below the table!
Like the riving knife, the dust shroud is mounted to the same cast iron boss as the blade.
That means it “follows” the blade through height and bevel changes to maintain
maximum effectiveness. We also offer as accessories the following riving knives -
#708682 - thin-kerf riving knife, #708683 - low profile standard kerf riving knife,
#708684 - low-profile, thin-kerf riving knife.
JET XACTA-FENCE II Commercial
Our JET XACTA-FENCE II, available in 30” and 50” capacity versions enhances
accuracy, performance and safety. The JET XACTA-FENCE II is based on the highly
regarded T-square design but uses high quality materials and manufacturing processes to
create an exceptionally accurate, durable and easy to use fence system.
The JET XACTA-FENCE II is
built using heavy steel
components that are precision
welded to insure accuracy and
long-term durability. Even the
locking mechanism parts have
been given special attention and
made using a high-tech
powdered metal process. Though
considerably more expensive, the
powdered metal process creates
exceptionally accurate and
durable parts.
built using heavy steel
components that are precision
welded to insure accuracy and
long-term durability. Even the
locking mechanism parts have
been given special attention and
made using a high-tech
powdered metal process. Though
considerably more expensive, the
powdered metal process creates
exceptionally accurate and
durable parts.
The JET XACTA-FENCE II uses high-end materials that are precisely
welded to make a tough, accurate fence system. The T-square head
(right) has simple adjuster screws and an adjustable magnified cursor
built in. the locking mechanism is made from powdered metal parts
for extended durability.
The T-square head has easy-to-use adjusting screws for squaring the faces to the table
surface and the fence face to the miter slots. Both adjustments are important and easy to
make, plus they stay adjusted for a long time! An adjustable, magnified cursor lens in the
T-square head makes reading the factory applied scale tape easy and accurate.
In place of the common laminate-covered wood materials, the JET XACTA-FENCE II
fence faces are made from a pair of ¾”-thick HDPE (high density polyethylene) slabs.
HDPE is very rigid, flat and has exceptional lubricity properties that allows wood to slide
along the faces easily and predictably. The faces can be adjusted vertically to ride just
above the table or flush with the surface, whichever is safest for the job at hand or your
preference. Oversized access holes along the underside of the JET XACTA-FENCE II
make reaching the fasteners that secure the HDPE fence faces easy.
surface and the fence face to the miter slots. Both adjustments are important and easy to
make, plus they stay adjusted for a long time! An adjustable, magnified cursor lens in the
T-square head makes reading the factory applied scale tape easy and accurate.
In place of the common laminate-covered wood materials, the JET XACTA-FENCE II
fence faces are made from a pair of ¾”-thick HDPE (high density polyethylene) slabs.
HDPE is very rigid, flat and has exceptional lubricity properties that allows wood to slide
along the faces easily and predictably. The faces can be adjusted vertically to ride just
above the table or flush with the surface, whichever is safest for the job at hand or your
preference. Oversized access holes along the underside of the JET XACTA-FENCE II
make reaching the fasteners that secure the HDPE fence faces easy.