Maytag medc500 用户手册

11. When the dryer has been running for 5 minutes, open the 

dryer door and feel for heat. If you feel heat, cancel cycle and 

close the door.
If you do not feel heat, turn off dryer, and check the 

There may be 2 household fuses or circuit breakers for 

 

■

the dryer. Check that both fuses are intact and tight, or 

that both circuit breakers have not tripped. If there is still 

no heat, contact a qualified technician.

noTE: You may notice an odor when the dryer is first heated. 

This odor is common when the heating element is first used.  

The odor will go away.

You can change your door swing from a right-side opening to a 

left-side opening, if desired.

1.  Place towel (A) on top of dryer to avoid damaging the surface.
2.  Open dryer door. Remove bottom screws from cabinet side of 

hinges (C). Loosen (do not remove) top screws from cabinet 

side of hinges.

3.  Lift door until top screws in cabinet are in large part of hinge 

slot. Pull door forward off screws. Set door on top of dryer. 

Remove top screws from cabinet.

4.  Use a small, flat-blade screwdriver to gently remove 4 hinge 

hole plugs (D) on left side of cabinet. Insert plugs into hinge 

holes on right-hand side of cabinet.

5.  Insert screws into bottom holes on left side of cabinet. 

Tighten screws halfway. Position door so large end of door 

hinge slot is over screws. Slide door up so screws are in 

bottom of slots. Tighten screws. Insert and tighten top screws 

in hinges.

6.  Close door and check that door strike aligns with door catch 

(B). If needed, slide door catch left or right within slot to adjust 

alignment.

1.  Place towel (A) on top of dryer to avoid damaging the surface.
2.  Open dryer door. Remove bottom screws from cabinet side of 

hinges (D). Loosen (do not remove) top screws from cabinet 

side of hinges.

3.  Lift door until top screws in cabinet are in large part of hinge 

slot. Pull door forward off screws. Set door (handle side up) 

on top of dryer. Remove top screws from cabinet.

4.  Remove screws attaching hinges to door.
5.  Remove screws at top, bottom, and side of door (4 screws). 

Holding door over towel on dryer, grasp sides of outer door 

and gently lift to separate it from inner door. Do not pry apart 

with putty knife. Do not pull on door seal or plastic door 

catches.