Maytag MHW6000X 安装指导

 To avoid floor damage, set washer onto cardboard 

before moving it.

It is necessary to remove all shipping materials for proper  

operation and to avoid excessive noise from washer. 
Move washer to within 4 ft (1.2 m) of its final location. It must  

be in a fully upright position.

n

A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical 

supply is required. A time-delay fuse or circuit breaker is  

recommended. It is recommended that a separate circuit 

breaker serving only this appliance be provided.

n

  This washer is equipped with a power supply cord having  

a 3 prong grounding plug.

n

  To minimize possible shock hazard, the cord must be plugged 

into a mating, 3 prong, grounding-type outlet, grounded in  

accordance with local codes and ordinances. If a mating outlet 

is not available, it is the personal responsibility and obligation 

of the customer to have the properly grounded outlet installed 

by a qualified electrician.

n

  If codes permit and a separate ground wire is used, it is  

recommended that a qualified electrician determine that  

the ground path is adequate.

n

Do not ground to a gas pipe.

n

Check with a qualified electrician if you are not sure the 

washer is properly grounded.

n

  Do not have a fuse in the neutral or ground circuit.

This washer must be grounded. In the event of a malfunction 

or breakdown, grounding will reduce the risk of electrical 

shock by providing a path of least resistance for electric 

current. This washer is equipped with a cord having an 

equipment-grounding conductor and a grounding plug. The 

plug must be plugged into an appropriate outlet that is 

properly installed and grounded in accordance with all local 

codes and ordinances.

Improper connection of the equipment-

grounding conductor can result in a risk of electric shock. 

Check with a qualified electrician or serviceman if you are in 

doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance – if it will 

not fit the outlet, have a proper outlet installed by a qualified 

electrician.
For a permanently connected washer:

This washer must be connected to a grounded metal, 

permanent wiring system, or an equipment grounding 

conductor must be run with the circuit conductors and 

connected to the equipment-grounding terminal or lead on 

the appliance.

Locate four transport bolts on rear of washer.