Dynaudio mc15 用户指南
Positioning
Dynaudio MC 15
5
Positioning
Note: Be aware that proper air circulation around the monitor for
sufficient cooling is necessary. Also notice that the heat sink is
designed to provide maximum cooling when the monitor is
positioned vertically.
designed to provide maximum cooling when the monitor is
positioned vertically.
To achieve optimal performance:
1. Place speakers on stands or on a desk, ideally with the included
1. Place speakers on stands or on a desk, ideally with the included
base plate.
2. Aim speakers towards the listener in both vertical and horizontal
planes.
When using the base plate:
1. Attach the small self-adhesive felt pieces to the edges on the
1. Attach the small self-adhesive felt pieces to the edges on the
bottom of the metal base plinths in order to prevent such from
scracthing desks.
scracthing desks.
2. Attach the self-adhesive rubber pieces to the top of the base plinth
surface to ensure secure loudspeaker placement.
Using the grille
A cloth grille is included and can be affixed to the cabinet to help protect
the drivers from dust and any other influences. The grille is acoustically
optimized, but the highest sound quality levels will be attained without
any grille covers in place during listening.
the drivers from dust and any other influences. The grille is acoustically
optimized, but the highest sound quality levels will be attained without
any grille covers in place during listening.
To fit the grille:
X Line up the posts with the corresponding front baffle receptacles
X Line up the posts with the corresponding front baffle receptacles
and gently push the grille in at all corners.
To remove the grille:
X Gently pull the grille at all corners straight away from the front.
X Gently pull the grille at all corners straight away from the front.
Connecting
NOTICE: Avoid hot plugging the equipment connected to the
monitors. Always turn of off the speaker and other
equipment when plugging or unplugging signals.
equipment when plugging or unplugging signals.
Connecting the speakers to the source
As an active speaker the MC 15 is equipped with internal power
amplifiers and must only be connected to a NF signal source (e.g.
Preamplifier, surround decoder, PC sound board,...).
1. Make sure the speakers are switched off.
2. From the right Pre Out of your preamplifier connect a mono RCA
amplifiers and must only be connected to a NF signal source (e.g.
Preamplifier, surround decoder, PC sound board,...).
1. Make sure the speakers are switched off.
2. From the right Pre Out of your preamplifier connect a mono RCA
cable to the Input of the right speaker.
3. From the left Pre Out of your preamplifier connect a mono RCA
cable to the Input of the left speaker.
Note: Use high quality cables only. This will improve the sound quality
and help the MC 15 speakers to realize their full potential.
Connecting a subwoofer
The MC 15 may be combined with a Dynaudio subwoofer such as the
Sub 250MC for extended bass performance and a higher sound
pressure level if the high pass filter is used (see “Cutting off low
frequencies” on page 7).
For information about connecting the MC 15 speakers in combination
with a subwoofer please refer to the subwoofer operating manual.
Sub 250MC for extended bass performance and a higher sound
pressure level if the high pass filter is used (see “Cutting off low
frequencies” on page 7).
For information about connecting the MC 15 speakers in combination
with a subwoofer please refer to the subwoofer operating manual.