Electrolux sc6051 用户指南
4
Operating instructions
WARNING- To reduce the risk of fire, electric shock or injury; only
use dryer as described in this manual.
Plug in to a standard outlet with the correct voltage and amperage for the unit.
Place the dryer in the desired operating position.
Set the switch at the desired speed: low, medium or high.
Check for proper operation before leaving the unit unattended. Do not move or
Place the dryer in the desired operating position.
Set the switch at the desired speed: low, medium or high.
Check for proper operation before leaving the unit unattended. Do not move or
carry the dryer when it is running.
Unwrap cord before using.
Unwrap cord before using.
3 position switch
cord wrap
unit in vertical position
Maintenance/Trouble Shooting
WARNING: To reduce the risk of fire, electric shock or injury; Do not attempt to service the unit while
appliance is plugged in.
Periodic Maintenance
1. Check power cord for any breaks, seperations or cuts.
2. Make sure the ground pin or grounding prong is intact or the machine will be unsafe to operate.
2. Make sure the ground pin or grounding prong is intact or the machine will be unsafe to operate.
Trouble Shooting
(if the dryer will not run)
1. Check electrical cord; is it firmly seated in wall outlet
2. Check GFCI and reset if tripped
3. Check to see if building circuit breaker is tripped. If circuit is overloaded, move cord to different GFCI outlet.
4. If using an extension cord, make sure it is in good condition, proper gauge and firmly connected.
5. Motor overheated and tripped thermal protection; turn off and unplug. Wait 30 minutes to let cool before running.
2. Check GFCI and reset if tripped
3. Check to see if building circuit breaker is tripped. If circuit is overloaded, move cord to different GFCI outlet.
4. If using an extension cord, make sure it is in good condition, proper gauge and firmly connected.
5. Motor overheated and tripped thermal protection; turn off and unplug. Wait 30 minutes to let cool before running.
Telescoping handle
and wheels available
on some models.
To use, push in
release button, pull
handle up until it
locks into place. Tilt
the unit back onto
the wheels and roll
to desired location.