iRobot 330 用户指南

iRobot Looj 300 Series Owner’s Manual

Remote Control Handle Led:

What it means

Solid Green

This indicates that the power is on, battery is charged, and all

communication is okay. This light will only be on when robot is

moving.

Slow Blinking Green

This occurs for 5 seconds to indicate that the remote has connected

to the robot.

Solid Yellow

This indicates that the robot and remote have a low signal strength.

Stop forward progress and return the robot to you. Driving the robot

out of range risks losing communication and control of the robot.

Slow Blinking Yellow

This occurs for 15 seconds to indicate that the remote has lost

connection with the robot. If this occurs, move closer to the robot

making sure you are within range of the robot - 15 m (45 ft). Also,

make sure that the robot is powered on.

Fast Blinking Yellow

This indicates that the robot has sensed tough debris. The robot will

over-ride your commands until it is clear of the debris, at which point

you can begin commanding the robot again. Note: This warning does

not occur in “CLEAN” mode. The robot will change its behaviors

automatically in “CLEAN” mode.

Solid Red

This indicates that the robot has encountered a failure. You must

retrieve the robot and attempt to reset the power button. Make sure

to clear the robot of any debris jams and ensure all batteries are fresh

or fully charged. If the solid red LED remains, please call a cutomer

care representitive to help troubleshoot your robot.

Slow Blinking Red

This indicates a low battery. If in use, return the robot to you

immediately, then charge the robot’s battery and use fresh batteries

in the remote.

Robot Led:

What it means

Solid Green

This indicates that the power is on, the battery is charged and all

communication is okay.

Slow Blinking Green

This occurs for 5 seconds to indicate that the robot has connected

to the remote.

Solid Yellow

This indicates that the robot has a weak signal strength.

Slow Blinking Yellow

This occurs if the robot has lost connection with the remote.