iRobot 350 用户指南

下载
页码 30
1
iRobot Scooba Owner’s Manual
 
Scooba’s Cleaning System
Scooba uses four cleaning methods in every pass.  
1
  
Preps – Scooba picks up loose dirt and light debris from the floor.  
You do not need to sweep the floor before using Scooba unless you  
have large objects such as pebbles or large food particles on the floor. 
2
  
washes – Scooba continuously lays down a small amount of fresh    
cleaning solution. 
3
  
scrubs – Scooba gently scrubs to clean spills and grime. 
  
Dries – Scooba’s squeegee vacuum picks up dirty water and debris,    
leaving your floor clean and dry. 
Scooba will clean until it has used all of the solution in the Clean tank, 
approximately 45 minutes. At the end of a cleaning cycle, Scooba will enter 
a drying mode. 
Internal Drying Mode
At the end of the cleaning cycle, Scooba will enter a brief internal drying 
mode to remove any liquid remaining on its brushes and inside its cleaning 
mechanisms. During this time Scooba’s Clean light will blink. 
TIP:  If you wish to end a cleaning cycle early, irobot recommends activating the 
internal drying mode first: 
• To start drying mode while the robot is cleaning, just press Clean. 
•  To start drying mode when scooba is off, press Power and then press 
Clean twice.
1
2
3