Runco SP-42 用户指南

Proper installation of your CinemaWall will ensure the highest possible picture quality. 
Whether you are installing the CinemaWall temporarily or permanently, you should take 
the following into account to ensure that it performs optimally.

Due to the design of all plasma glass panels made by every manufacturer, and the 
interaction between ambient air pressure and the plasma gases contained inside of the 
panel, reliable operation of your plasma display cannot be assured during operation at 
certain high-altitude locations.

Runco has found the SP-42, SP-50 and SP-60 to operate reliably at altitudes of up to 
6000 feet MSL (mean sea level). The SP-42xa, SP-50xa and SP-60xa have been found to 
operate reliably at altitudes of up to 9000 feet MSL.

At higher elevations, each panel may react differently, depending upon the altitude, air 
pressure, humidity and other meteorological factors. If you are planning to use this 
product at a location above 9000 feet, please contact Runco technical support for further 
information.

To install the CinemaWall, you will need either an optional table stand or wall-mounting kit. 
The CinemaWall cannot be installed on its own. 

If you do decide to wall-mount the CinemaWall, ensure that the wall-mount bracket is 
installed according to the instructions included with it. The wall must be capable of 
supporting a redundant weight factor three (3) times the weight of the display, or be 
reinforced. 

Runco recommends that this be done by a custom installation specialist.

You can attach your optional mounts or stand to the CinemaWall in either of two ways: 

• While it is upright.

 

 

 

 

 

 

 

 

 

 

 

 

 

➤

➤