Runco rs 440lt 用户指南
34
Runco RS-440 Installation/Operation Manual
PRE
L
IMINAR
Y
1.
Use the Height/Pitch Adjustment
Screws (2) and Washers (3) to attach
the Lens Mounting Bracket (5) to the
Anamorphic Lens (1).
Screws (2) and Washers (3) to attach
the Lens Mounting Bracket (5) to the
Anamorphic Lens (1).
2.
Remove the nut and rubber collar
from each Swell Latch Assembly (4).
from each Swell Latch Assembly (4).
3.
Secure the lens (with the mounting
bracket attached) to the Lens Base
Plate (6) using the swell latches.
bracket attached) to the Lens Base
Plate (6) using the swell latches.
Adjusting the Lens Height and Angle:
1.
Project a white field on the screen.
2.
Loosen the four Height/Pitch Adjustment Screws just enough to allow vertical
movement of the lens assembly.
movement of the lens assembly.
3.
Slowly move the anamorphic lens into place so that there are no shadows on the top
or bottom of the screen:
or bottom of the screen:
To avoid clipping the corners of the image, position the anamorphic
lens as close as possible to the primary lens.
lens as close as possible to the primary lens.
Tip
Too High
Too Low
Correct position