Runco vx-2cx 用户指南
40
Runco VX-2cx/VX-2dcx Owner’s Operating Manual
PRE
L
IMINAR
Y
1.
Remove the two, Female Z-Adjustment Levers (item #10b) and 1/4-20 Fiber Washers
(item #14) from the Z-Adjustment Plate (item #5).
(item #14) from the Z-Adjustment Plate (item #5).
2.
Place the Lens Mounting Assembly on top of (or under, if the projector is inverted) the
Lens Motor Carriage Plate or Base Plate (item #12), so that the two threaded posts at
the bottom of the Z-Adjustment Plate pass through the corresponding slots on the
carriage plate or base plate.
Lens Motor Carriage Plate or Base Plate (item #12), so that the two threaded posts at
the bottom of the Z-Adjustment Plate pass through the corresponding slots on the
carriage plate or base plate.
3.
Secure the Lens Mounting Assembly to the plate with the Z-Adjustment Levers and
Washers that you removed in Step 1.
Washers that you removed in Step 1.
4.
Place the Anamorphic Lens (item #16) inside the Lens Ring (item #1). Using a 1/4” hex
wrench, tighten the two Nylon Set Screws (item #2) on the Lens Ring to secure the
lens in place.
wrench, tighten the two Nylon Set Screws (item #2) on the Lens Ring to secure the
lens in place.
6
X-Adjustment Plate
1
7
Screw, Slide Head
2
8
Pitch Adjustment Lever, Female
2
9
Y-Adjustment Lever, Male
2
10a
Yaw/X-Adjustment Lever, Female
2
10b
Z-Adjustment Lever, Female
2
11
Screw, Countersink
4
12
Carriage Plate (CineWide with AutoScope) or Base Plate
(Fixed CineWide, not shown)
(Fixed CineWide, not shown)
1
13
Washer, Fiber #10
6
14
Washer, Fiber
1/4-20
2
15
Lens Motor
1
16
Anamorphic Lens
1
If this is an AutoScope installation, leave enough space between
the projector and the lens mounting assembly to allow the lens to
move out of the light path without the assembly coming into
contact with the projector front jewelry.
the projector and the lens mounting assembly to allow the lens to
move out of the light path without the assembly coming into
contact with the projector front jewelry.
Item Number
Description
Quantity
Note