Runco VX-6000D 用户指南

下载
页码 110
40
Runco VX-6000d Installation/Operation Manual
PRE
L
IMINAR
Y
Projector: The projector is equipped with an additional 12-volt trigger output. This trigger 
activates when the projector is turned on. Connect it to your retractable screen or other, 
12-volt trigger-activated equipment as shown in Figure 3-17
Figure 3-17. 12-volt Trigger Output Connection (from Projector)
Connecting an External IR 
Receiver to the DHD 
Controller
If infrared signals from the remote control cannot reach the DHD Controller due to 
excessive distance or obstructions such as walls or cabinet doors, you can connect an 
external IR receiver to the DHD Controller to extend the range of the remote control. See 
Figure 3-18. 
Figure 3-18. External IR Receiver Connection
to retractable screen
or other, 12-volt
trigger-activated
equipment
Tip = +12V
Sleeve = Ground
(cylindrical,
DC power
supply-type
plug)
When an external IR receiver is connected to the wired IR input, the 
built-in IR sensor on the DHD Controller is disabled. 
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 Out
CAUTION:
 TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
WARNING: 
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
SYSTEM CONTROL INTERFACE
Made In USA
Ring = +5V
Tip = IR Input
Sleeve = Ground
(3.5-mm
mini phono 
plug)
IR Receiver
Remote
Control
Note