Matsunichi pf1009m 用户指南
5
www
.matsunichi.com
5
Remote Control Preparation & Use
The wireless remote control already has a battery installed.
To
enable the remote, you
will need to remove the battery protector as show below
.
1.
T
urn over the remote to the back cover
.
2. Pull the plastic tab to enable the battery in the remote.
Y
our remote is now ready for use.
Remote Control
Plastic T
ab
Pull
6
6
www
.matsunichi.com
Remote Control
Battery Holder
Release Clip
Handle
Using the Wireless Remote Control
The remote control works best when pointed
directly at the unit. Stay within a 30 degree
angle on either side of the unit.
Battery Polarity
To
replace the battery
, remove the battery holder from the remote control.
To
re-
move the battery holder
, use your thumb to squeeze the release clip in toward the
center
, while simultaneously pulling the handle out with your index
fi nger
.
Place the battery into the holder as pictured below with the POSITIVE SIDE
(marked on battery as “+”) facing upwards and insert into the remote control to
complete the battery installation.