Fortinet FORTIWIFI-50B 安装指导

Type D.
The FortiWiFi unit installs the new firmware image and restarts. The installation 
might take a few minutes to complete. 

Change the internal interface address, if required. You can do this from the CLI 
using the following command:

config system interface

edit <interface>

set ip <address_ip4mask>
set allowaccess {ping|https|ssh|telnet|http}

end

After changing the interface address, you can access the FortiWiFi unit from the 
web-based manager and restore the configuration.

Use a USB key to either backup a configuration file or restore a configuration file. 
You should always make sure a USB key is properly install before proceeding 
since the FortiWiFi unit must recognize that the key is installed in its USB port.

Log into the CLI.

Enter the following command to backup the configuration files: 

exec backup config usb <filename>

Enter the following command to check the configuration files are on the key:

exec usb-disk list

Log into the CLI.

Enter the following command to restore the configuration files:

exec restore image usb <filename>

The FortiWiFi unit responds with the following message:

This operation will replace the current firmware version! 

Do you want to continue? (y/n)

Type y.

The USB Auto-Install feature automatically updates the FortiGate configuration file 
and image file on a system reboot. Also, this feature provides you with an 
additional backup if you are unable to save your system settings before shutting 
down or rebooting your FortiWiFi unit.

Note: You can only save VPN certificates if you encrypt the file. Make sure the 
configuration encryption is enabled so you can save the VPN certificates with the 
configuration file. An encrypted file is ineffective if selected for the USB Auto-Install feature.