NorthStar 6000i 安装指导
SECTION TWO: Installing and wiring the radar
Page 6
Radar Installation Manual, Rev. E1
Referring to Figure 5 below and the supplied full-size antenna mounting templates, drill holes at the
specified locations in the mounting base. Using these holes and hexagonal bolts, install the antenna
to the mounting base. Use silicone to stop the bolts from loosening. The bolts supplied will suffice for
mounting base thicknesses of 0.35 to 0.55 inch (9 to 14 mm). If the mounting base is thicker or thin-
ner than that, use bolts specified in Table 3 or Table 4 on page 8.
specified locations in the mounting base. Using these holes and hexagonal bolts, install the antenna
to the mounting base. Use silicone to stop the bolts from loosening. The bolts supplied will suffice for
mounting base thicknesses of 0.35 to 0.55 inch (9 to 14 mm). If the mounting base is thicker or thin-
ner than that, use bolts specified in Table 3 or Table 4 on page 8.
details on bolting the antenna to the mounting base.
NOTE:
When the radar platform or mounting bracket has a curvature of more than
2mm, repair it or use spacers.
2mm, repair it or use spacers.
Figure 5: Hole positions for mounting antennas (radome or open array)
Figure 6: Mounting the radome antenna