Garmin 530 用户指南
4
TAKEOFF TOUR
The Garmin GNS 530 offers you accurate navigational data and communication ca pability, along with
non-precision and precision approach certifi cation in the IFR environment. The Takeoff Tour is designed
to familiarize you with the basic operation of the GNS 530 — in cluding powering up the unit, changing
frequencies, entering data, performing a simple direct-to, selecting IFR procedures and provides a limited
introduction to using fl ight plans. In ad dition, this section briefl y covers the default navigation, map and
frequency pages available as part of the NAV page group. These pages are used for most of your in-fl ight
navigation.
to familiarize you with the basic operation of the GNS 530 — in cluding powering up the unit, changing
frequencies, entering data, performing a simple direct-to, selecting IFR procedures and provides a limited
introduction to using fl ight plans. In ad dition, this section briefl y covers the default navigation, map and
frequency pages available as part of the NAV page group. These pages are used for most of your in-fl ight
navigation.
The Takeoff Tour assumes that the unit and antennas have been properly installed and you have not
changed any of the GNS 530’s default settings. If you have changed any of the factory default settings (po-
sition format, units of measure, selectable fi elds, etc.), the pictures shown here may not exactly match what
you see on your GNS 530. Prior to using your GNS 530 for the fi rst time, we recommend that you taxi to a
location that is well away from build ings and other aircraft so the unit can collect satellite data without inter-
ruption.
sition format, units of measure, selectable fi elds, etc.), the pictures shown here may not exactly match what
you see on your GNS 530. Prior to using your GNS 530 for the fi rst time, we recommend that you taxi to a
location that is well away from build ings and other aircraft so the unit can collect satellite data without inter-
ruption.
Powering up the GNS 530
The GNS 530’s power and COM volume are controlled using the COM power/volume knob at the top
left corner of the unit. Rotating it clockwise turns unit power on and increases the COM radio volume. After
turning the unit on, a Welcome Page is displayed while the unit performs a self test, followed by a Land Data
Page.
turning the unit on, a Welcome Page is displayed while the unit performs a self test, followed by a Land Data
Page.
The Database Confi rmation Page appears next and shows the current database information on the NavDa-
ta card (with the valid operating dates, cycle number and database type indicated). The database is updated
every 28 days and must be current for approved instrument approach operations. Information on database
subscriptions is available inside your GNS 530 package.
every 28 days and must be current for approved instrument approach operations. Information on database
subscriptions is available inside your GNS 530 package.
To acknowledge the database information, press the ENT key.
The Welcome Page appears when the GNS 530
is powered on. Dur ing the time this screen is dis-
played, the GNS 530 performs a self test to ensure
proper op er a tion.
is powered on. Dur ing the time this screen is dis-
played, the GNS 530 performs a self test to ensure
proper op er a tion.
The Database Page shows the effective and
expiration dates of the Jeppesen database on the
NavData Card.
expiration dates of the Jeppesen database on the
NavData Card.
Power On
i-60.indd 4
4/11/2003, 8:55:42 AM