Garmin 530 用户指南

15

TAKEOFF TOUR

Once the direct-to or fl ight plan is confi rmed, the whole range of instrument procedures is available to 

you. Departures (SIDs), arrivals (STARs), non-precision and precision ap proach es are stored within the Nav-
Data card and available using the PROC key.

The steps required to select and activate an approach, departure or arrival are very similar. In this in tro -

ductory section, we’ll show examples of the steps required to select an approach, but keep in mind the same 
process also applies to departures and arrivals.

1. Rotate the large right knob to highlight the “Select Approach?” option (or “Select Arrival?”/“Select De-

 par ture?”) from the Procedures Page.

2. Press ENT to display a list of available procedures for the arrival (when using approaches or STARs) or de-

 par ture (when using SIDs) airport.

3. Rotate the small right knob to select the desired procedure and press ENT.

4.  For approaches, a window appears to select the desired initial approach fi x (IAF) or a “vectors” option to select 

just the fi nal course segment of the approach. Rotate the small right knob to select the desired option and 
press ENT. (The “vectors” option extends the fi nal inbound course beyond the fi nal approach fi x, allowing you 
to intercept the fi nal course segment beyond its normal limits.)

5.  For departures and arrivals, pop-up windows appear to select the desired transition and runway(s). Rotate the 

small right knob to select the desired option and press ENT.

6.  With “Load?” highlighted, press ENT to add the procedure to the fl ight plan or direct-to.

The selected procedure for the departure or arrival airport is added to the sequence of waypoints in the 

fl ight plan or direct-to (as shown on the Active Route Page). You can later “activate” the selected procedure 
from the Procedures Page or the Active Flight Plan Page. See pages 56 and 62 for additional information.

i-60.indd   15

4/11/2003, 8:56:03 AM