Garmin 530 用户指南
44
3 - DIRECT-TO
Section 3: Direct-To Navigation
The GNS 530’s direct-to function provides a quick method of setting a course to a destination waypoint.
Once a direct-to is activated, the GNS 530 establishes a point-to-point course line (great circle) from your pres-
ent position to the selected direct-to destination. Navigation data on the various NAV pages provides steering
guidance until the direct-to is cancelled or replaced by a new des tination.
ent position to the selected direct-to destination. Navigation data on the various NAV pages provides steering
guidance until the direct-to is cancelled or replaced by a new des tination.
To select a direct-to destination:
1. Press the direct-to key. The Select Direct-to Waypoint Page appears, with the waypoint identifi er fi eld high-
light ed.
2. Use the small and large right knobs to enter the identifi er of the desired destination waypoint.
3. Press ENT to confi rm the selected waypoint and ENT (again) to activate the direct-to function.
If you’re navigating to a waypoint and get off course, the direct-to function may also be used to re-center
the CDI (HSI) needle and proceed to the same waypoint.
To re-center the CDI (HSI) needle to the same destination waypoint:
1. Press the direct-to key, followed by ENT twice.
NOTE: When navigating an approach with the missed approach point (MAP) as the current desti-
nation, re-centering the CDI (HSI) needle with the direct-to key cancels the approach.
nation, re-centering the CDI (HSI) needle with the direct-to key cancels the approach.
Pressing the direct-to key displays the Select
Direct-to Waypoint Page.
Direct-to Waypoint Page.
Selecting a Destination
)
Use the small and large right knobs to enter the
name of the destination waypoint. Press ENT once
the name has been fully entered.
name of the destination waypoint. Press ENT once
the name has been fully entered.
i-60.indd 44
4/11/2003, 8:56:36 AM