Garmin 530w 用户指南

197

VLOC remote transfer key is stuck — (GNS 530W 
only) The remote VLOC transfer switch is stuck in the 
enabled (or “pressed”) state. Try pressing the switch again 
to cycle its operation. If the message persists, contact your 
Garmin dealer for assistance. 
VLOC transfer key stuck — (GNS 530W only) The 
VLOC flip-flop key is stuck in the enabled (or “pressed”) 
state. Try pressing the VLOC flip-flop key again to cycle 
its operation. If the message persists, contact your Garmin 
dealer for assistance. 
Waypoint already exists — The name you have entered 
for a user waypoint already exists in memory. 
Waypoint(s) have been replaced — One or more user 
waypoints were updated during a unit-to-unit crossfill 
operation. 
Waypoint memory is full — You have used all 1000 user 
waypoint locations in the 500W-series unit memory. Delete 
unwanted waypoints to make room for new entries. 

Turn Advisory and Arrival Annunciations
The following annunciator messages may appear in the 
lower right corner of the 500W-series unit display: 
Arriving at waypoint — Arriving at the destination 
waypoint for the active leg. 
Hold direct — “Direct” holding pattern entry. 
Hold parallel — “Parallel” holding pattern entry. 
Hold teardrop — “Teardrop” holding pattern entry. 
Left to xxx° in xx sec — Turn advisory. Turn to the indi-
cated heading by the time shown. 
Left to xxx° now — Turn advisory. Turn to the indicated 
heading by the time shown. 
Next DTK xxx° in xx sec — Waypoint alert. Prepare to 
turn to the indicated heading upon waypoint passage. 
PTK end in xx sec — Parallel Offset is terminating. 
Right to xxx° in xx sec — Turn advisory. Turn to the 
indicated heading by the time shown. 
Right to xxx° now — Turn advisory. Turn to the indicated 
heading by the time shown.