Garmin 530w 用户指南

34

 

NOTE: If the 500W-series unit is unable to determine 
a GPS position, the present position (airplane) symbol 
will appear on the Map Page in yellow. No symbol will 
be present when there is no active flight plan. 

Various symbols are used to distinguish between 

waypoint types. The identifiers for any on-screen 
waypoints can also be displayed. (By default the identi-
fiers are enabled.)  Special-use and controlled airspace 
boundaries appear on the map, showing the individual 
sectors in the case of Class B, Class C, or Class D 
airspace. The following symbols are used to depict the 
various airports and navaids on the Map Page: 

  Airport with hard surface runway(s); Primary runway shown
   Airport with soft surface runway(s) only
   Private Airfield
   Intersection
   VOR
   VORTAC
   VOR/DME
   TACAN

    DME

   NDB

    Localizer

  Locator Outer Marker

    Heliport

The map display can be set to 23 different range 

settings from 500 feet to 2000 nautical miles (statute 
and metric units are also available). The range is indi-
cated in the lower left-hand corner of the map display, 
and represents the top-to-bottom distance covered by 
the map display. 

1.   Press  the  up  arrow  side  of  the  RNG  key  to 

zoom out to a larger map area. 

2.   Press  the  down  arrow  side  of  the  RNG  key 

to zoom in to a smaller map area and more 

detail. 

An autozoom feature is available which auto-

matically adjusts from an en route range of 200 NM 

through each lower range, stopping at a range of 

1.0 NM as you approach your destination waypoint. 

The autozoom feature is turned on/off from the map 

setup page described later in this section. 

The Map Page also displays a background map 

showing lakes, rivers, coastlines, highways, railways 

and towns. When a map scale is selected below the 

lower limit at which the map detail was originally 

created, an “overzoom” indication appears on the map 

display, below the scale reading. “Overzoom” indicates 

that the detail at this scale may not accurately repre-
sent actual conditions (and extra caution should be 
observed when these scales are used for navigation). 

The “Setup Map?” option allows you to define the 

maximum scale at which each map feature appears. 
This provides you with complete control to minimize 
screen clutter. You can also quickly remove items from 

Map Page