Sonance extreme xsstr 用户指南

Speakers and grilles can be painted before installation, which will

eliminate the "paint scar" if the speaker needs to be removed for

service. Speakers may also be painted after installation, but before the

grilles are attached. All speakers come from the factory fitted with a

plastic "paint plug." Use the paint plug to protect the drivers while the

flange is being painted with the wall.

Sonance suggests always painting the grilles separate from the

speaker. The grilles may be lightly sprayed with thin paint (5 parts

thinning agent to 1 part paint), but be careful not to plug the holes.

Too much paint will adversely affect the sound of the speaker.

Once the grilles and flange are painted and dry, remove the paint plug

from the flange and install the grilles.

Make sure the Roto-Lock clamps are in

the full clockwise position so that all the

clamps are tucked within the cutout

border. Insert the speaker into the hole

in the ceiling.

Note: The maximum clamp thickness is

1-1/4" (32mm). The minimum clamping

thickness is 1/8" (3.2mm)

Tighten the six screws on the front of

the baffle. The Roto-Lock clamps will

rotate into position automatically and

begin clamping. When you notice

resistance on the four screws, the

speaker has been clamped successfully.

The flange is designed to flex and

conform to any small imperfections in

the wall surface. The screws should not

be tightened so far that the flange bows

out.

Remove the paint plug from the

speaker. Attach the wire from your

amplifier to the terminals on the back of

the speaker. Double check the polarity

of the speaker wires, amplifier + to

speaker + and amplifier - to speaker -.

Proper polarity is critical in home theater

installations.

After the speaker is installed, the grille

can be installed. Insert about half of the

grille into the groove at the edge of the

speaker. Gently fit the remaining half of

the grill into the speaker by working

your hands around the speaker fitting

the grille into the groove as you go

along.

Note: The torque applied to the

mounting screws can be adjusted for

proper grille fit.