Videolarm qfdpt3-50na 用户指南

!

!

               Power 24VAC, Class 2 Only 

26 watts at 24 VAC (accessories)

Heater:  25 watts 

Blower:  .84 watts 

Input Connectors (outdoor units):  

          BNC Connectors - 1 for each camera 

          Screw-down connectors - 2

     NOTE:  This unit is designed for operation in an 

                  upright position. Installing the Fusionome™ 

                  upside down may cause damage to the 

                  internal equipment, and will void the warranty. 

CAMERAS     VOLTAGE           CURRENT       POWER

        1              24 VAC/VDC     102mA              2.5W

        2              24 VAC/VDC      210mA             5W

        3              24 VAC/VDC      331mA             7.9W

        4              24 VAC/VDC      487mA             10.9W

Use the formula below to select the correct power supply for 
cameras connected in parallel (positive to positive, negative to 
negative):

Total current for a 24 VAC system:
TOTAL CURRENT = (202mA x total number of cameras)
                                  Note: 202mA is camera plus power supply 

This chart shows the proper current needed for power supplies for 
Q-View™ cameras. Use Class 2 Power only. Input voltage must 
be 24 VAC/VDC.

3.   Pull the wires from the wall through the rectangular hole in the 

      wall mount bracket.  Attach the wall mount to the wall using 

      appropriate hardware (not included).

4.   Make all wiring connections (See next page). Attach the BNC 

      connectors to the video in.

5.   Once all wiring connections are made, place the wires inside the

      wall mount bracket and close the access door. Secure with the

      screw removed earlier.

1.    A template is included as a guide for mounting the bracket to a

       wall.  Choose the desired location for installation and mark the 

       drill holes using the template. Run approximately 8"of wiring out 

       of the wall.

2.    Open the access door on the bottom of the wall mount by 

       loosening the screw nearest the mounting plate (Figure 1).

Figure 1

Access door

Tools Required:  .100" Flat Head Screwdriver

                             Phillips Head Screwdriver

Carefully remove the housing from the packaging material. Check to 

be sure all parts are present.

1.  This unit includes a 1 1/2" NPT housing coupling that can be used

     with a standard 1 1/2" NPT pipe or with brackets designed with 

     1 1/2" male pipe threads, such as Videolarm's WM20G.

2.  Attach the coupling to the bracket or pendant pipe (Figure 2).

     NOTE:  Pipe threads should be clean and rust free.   Use a 

                  sealer (such as Tefl on™ tape or silicone sealer) on the 

                  threads for outdoor applications 

Be sure the bracket is properly and securely mounted to a 

supporting structure capable of rigidly holding the weight of 

the entire unit.  

Figure 2

Add thread 
sealing tape