Videolarm qrhpc2-50na 用户指南

               Power 24VAC, Class 2 Only 

26 watts at 24 VAC Heater and Blower

Heater:  25 watts 

Blower:  1 watt 

Input Connectors (outdoor units):

          Camera Power, BNC 

          (2) screw-down connectors

NOTE:  This unit is designed for operation in an upright 

                  position. Installing the QRH  upside down may

                  cause damage to the internal equipment, and

                  will void the warranty. 

Be sure the bracket is properly and securely mounted to a 

supporting structure capable of rigidly holding the weight of 

the entire unit.

1.  Open the housing by loosening the (3) captive screws 

     located on the housing ring next to the lower clear dome 

     (Figure 1). Be careful not to back these all the way out.  Twist the 

     dome slightly in a counterclockwise motion until it stops, then pull 

     down to remove. 

NOTE: 3 Security screws are provided in packet assembly 

if desired

2.  Clean the inside of the dome. Reattach the housing dome and 

     secure the (3) captive screws. Do not overtighten the screws.

     Tighten only to the point at which the gap between the ring and 

     the housing top closes (screws should be tightened to 12" lbs. 

max).

     A wall mount bracket comes standard with this unit, and a 

     template is included to use as a guide for mounting the bracket 

     to a wall.  Choose the desired location for installation and mark 

     the drill holes using the template.  Mount the wall mount bracket 

to the wall with (4) bolts (not provided).  Run approximately 8" of 

wiring out of the wall and into the wall mount.

     

NOTE: Be sure the hardware and the mounting surface can support 

the weight of the wall mount bracket plus the weight of the 

housing and drive unit. The load will be subjected to vibration 

from the camera motor and wind.

2.  The wall mount bracket provided with the rugged housing includes

     a location for conduit entry.  If you wish to install conduit to the 

     bracket remove the conduit hole plug.  Install fitting from below the 

     wall mount and secure with conduit nut from inside the bracket.

Tools Required:  .100" Flat Head Screwdriver

                             Phillips Head Screwdriver

                             Tamper-proof Allen wrench (supplied)

CAMERAS     VOLTAGE           CURRENT       POWER

        1              24 VAC/VDC     102mA              2.5W

        2              24 VAC/VDC      210mA             5W

        3              24 VAC/VDC      331mA             7.9W

        4              24 VAC/VDC      487mA             10.9W

Use the formula below to select the correct power supply for 
cameras connected in parallel (positive to positive, negative to 
negative):

Note: 202mA is camera plus power supply 

This chart shows the proper current needed for power supplies for 
Q-View™ cameras. Use Class 2 Power only. Input voltage must 
be 24 VAC/VDC.