Videolarm qsdpc2-70na5 用户指南
- 4 -
Figure 4
Twist and
Secure
Secure
FOR OPTIONAL PENDANT MOUNT
1. This unit includes a 1 1/2" NPT housing for a standard 1 1/2"
NPT pipe. The RH7C can be used with other brackets
designed with 1 1/2" male pipe threads, such as the Videolarm
WM20G and WM20 wall mount brackets.
1. This unit includes a 1 1/2" NPT housing for a standard 1 1/2"
NPT pipe. The RH7C can be used with other brackets
designed with 1 1/2" male pipe threads, such as the Videolarm
WM20G and WM20 wall mount brackets.
2. Attach the housing coupling (Figure 3).
NOTE: Pipe threads should be clean and rust free. Use a sealer
NOTE: Pipe threads should be clean and rust free. Use a sealer
(such as Teflon™ tape or silicone sealer) on the threads.
Wiring Color Code for Power
1
Camera Power (24 VAC)
Red
2
Camera Power (24 VAC)
Orange
3
Accessory Power (24 VAC)
Yellow
4
Accessory Power (24 VAC)
Green
POWER
4. Attach the wires from the wall to the connector provided, using the
wiring color code chart as a guide.
wiring color code chart as a guide.
5. Once all wiring connections are made, place the wires inside the
wall mount bracket and close the access door. Secure with the
screw removed earlier.
wall mount bracket and close the access door. Secure with the
screw removed earlier.
6. Clean the outside of the dome.
Figure 2
Conduit Entrance
3. Open the access door on the bottom of the wall mount by
loosening the screw nearest the mounting plate (Figure 2).
loosening the screw nearest the mounting plate (Figure 2).
Figure 3
Add thread
sealing tape
sealing tape
1. Mount the housing assembly to the mounting bracket and
housing coupling. A safety cable is included with the housing to
temporarily hold it while making wiring connections.
housing coupling. A safety cable is included with the housing to
temporarily hold it while making wiring connections.
2. Clean the outside of the dome.