Bosch 1006vsr 3 用户指南
9
2. Flip
up
the latch (J) and slide out the upper
wheel axle (K) while holding the wheel.
Figure 4
3. Carefully remove the upper wheel (D) and
set it on a bracket on the upper wheel rack.
4. Place a new upper wheel into position. Align
the wheel bearing holes with the bracket
mounting holes, insert the axle (K), and
rotate the latch (J) to secure the wheel.
mounting holes, insert the axle (K), and
rotate the latch (J) to secure the wheel.
Note: Adjust the lower wheel height if you
need more clearance replacing the upper
wheel.
need more clearance replacing the upper
wheel.
To replace a lower wheel:
1. Disengage
the
quick release lever (F, Figure
4) and lower the lower wheel bracket (H,
Figure 4) until there’s sufficient clearance.
Figure 4) until there’s sufficient clearance.
2. Remove
the
lower wheel (E, Figure 4) and
replace it with another one.
3. Engage the quick release lever (F, Fig. 2)
and raise the lower wheel to the operating
position.
position.
Rotating Wheels
The wheels can be positioned perpendicular to
the frame (A, Figure 5) for long workpieces or
parallel to the frame (B, Figure 5) for wide
workpieces.
the frame (A, Figure 5) for long workpieces or
parallel to the frame (B, Figure 5) for wide
workpieces.
Figure 5
To rotate lower wheel:
Refer to Figure 6.
1. Disengage
quick release lever (F).
2. Remove lower wheel if needed for
clearance.
3. Lift the lower wheel assembly until the
knurled screw (L) reaches the top of the
groove in which it is currently positioned
(L
groove in which it is currently positioned
(L
1
).
Figure 6
4. Rotate the lower wheel assembly, sliding the
knurled screw (L) along the entire distance
of the horizontal groove (L
of the horizontal groove (L
2
).
5. Lower the lower wheel assembly until it reaches
the bottom of the opposite groove (L
3
).